The results of the comparison of parallel thread gauges between ten European countries are presented. Three thread plugs and three thread rings were calibrated in one loop. Croatian National Laboratory for Length(HMI/FSB-LPMD) acted as the coordinator and pilot laboratory of the comparison. Thread angle, thread pitch, simple pitch diameter and pitch diameter were measured. Pitch diameters were calibrated within 1a, 2a, 1b and 2b calibration categories in accordance with the EURAMET cg-10 calibration guide. A good agreement between the measurement results and differences due to different calibration categories are analysed in this paper. This comparison was a first EURAMET comparison of parallel thread gauges based on the EURAMET cg-10 calibration guide, and has made a step towards the harmonization of future comparisons with the registration of CMC values for thread gauges.

Final report on EURAMET.L-S21: `Supplementary comparison of parallel thread gauges' / Mudronja, Vedran; Šimunovic, Vedran; Acko, Bojan; Matus, Michael; Bánréti, Edit; István, Dicso; Thalmann, Rudolf; Lassila, Antti; Lillepea, Lauri; Picotto, Gianbartolo; Bellotti, Roberto; Pometto, Marco; Ganioglu, Okhan; Meral, Ilker; Antonio Salgado, José; Georges, Vailleau. - In: METROLOGIA. - ISSN 0026-1394. - 52:1A(2015), pp. 04003-04003. [10.1088/0026-1394/52/1A/04003]

Final report on EURAMET.L-S21: `Supplementary comparison of parallel thread gauges'

Picotto, Gianbartolo;Bellotti, Roberto;POMETTO, MARCO;
2015

Abstract

The results of the comparison of parallel thread gauges between ten European countries are presented. Three thread plugs and three thread rings were calibrated in one loop. Croatian National Laboratory for Length(HMI/FSB-LPMD) acted as the coordinator and pilot laboratory of the comparison. Thread angle, thread pitch, simple pitch diameter and pitch diameter were measured. Pitch diameters were calibrated within 1a, 2a, 1b and 2b calibration categories in accordance with the EURAMET cg-10 calibration guide. A good agreement between the measurement results and differences due to different calibration categories are analysed in this paper. This comparison was a first EURAMET comparison of parallel thread gauges based on the EURAMET cg-10 calibration guide, and has made a step towards the harmonization of future comparisons with the registration of CMC values for thread gauges.
File in questo prodotto:
File Dimensione Formato  
EURAMET.L-S21.pdf

solo utenti autorizzati

Tipologia: final published article (publisher’s version)
Licenza: Non Pubblico - Accesso privato/ristretto
Dimensione 3.24 MB
Formato Adobe PDF
3.24 MB Adobe PDF   Visualizza/Apri   Richiedi una copia

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11696/57135
Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus ND
  • ???jsp.display-item.citation.isi??? 1
social impact